TS Components | TS System | Products | About Us

Products

TS System Technical Brochure
5.8 MB

Download

All News

The basic T/S Panel System is supplied in two EPS material types (white or grey).

Better thermal 'u' values are obtained by laying EPS White or EPS Grey Jablite insulation board over the basic panel system.

Where the panels have to be cut to length (the standard length 1220mm) the minimum permissible cut length is 300mm.

TS Start & TS End Panels

Used to eliminate the need for aerated blocks around the perimeter of the floor. These abut to the inside face of the internal skin wall but must NOT form part of the wall.
Make Up Sheet

100x440x1200mm.
Half Panel

Top Sheet Insulation Board

Various Depths of 75mm and above. Laid over the beams and panels. 1200x2400mm.
Perimeter Edge Strips

1200x75x30mm polystyrene Edge Strips are laid around the perimeter of the floor on the inside of the inner leaf to prevent cold bridging.
Poly Closure Blocks

Used at the end of the run of panels between the beam ends, over the supporting wall, to avoid the need to cut blocks/bricks to size. (Sold in packs of 60).

Slip Bricks

385x100x45mm are available, if required, sold in packs of 204.
Airbricks

Supplied in four colours, Terracotta, Buff, Blue/Black and Brown to complement the outer skin of brickwork. (The colours below are a guide only).
Telescopic Cranked Underfloor Ventilators & Airbricks

Used to ventilate the void beneath the floor and come with airbricks. Ventilators are available in standard 2-3 courses or extended 5-8 courses. The Extended Ventilator is usually used with deep insulated floor finishes, particularly EPS infill panels.

Speak to our experienced team on:
01924 455 876